[. . . ] Disassembling The RoadGear To follow is the most convenient way to open and close the RoadGear kits. [. . . ] Connect the two speakers to the Powered Mixer, via the supplied speaker cable. An optional speaker stand may be used to increase the height of the speakers. NB. No devices other than speakers should be connected to the speaker outputs. Also, guitar cables should not be used to connect amplifiers to speakers. 3. Plug all necessary instruments and equipment into the device's various inputs as required. This may include line-signal devices, as well as microphones and/or guitars, keyboards, etc. This could include monitors, signal processors, and/or recording devices. Plug the supplied AC cable into the AC inlet on the back of the RoadGear mixer. NB. [. . . ] Latch Position Please ensure, after unpacking the RoadGear set, that the docking locks on the speakers are locked back into place, to ensure the locks do not scratch the surface on which the speaker is standing. PHONIC CORPORATION RoadGear User's Manual page 13 es es es des CV [. . . ]